Configure PBX Connector using IP authentication

[fmateo05]

I have configured  PBX connector  via username and password authentication method. How i can connect remote PBX using IP authentication?  Note that I did search google and kazoo documentation with no accurate information about.

 

[nick]

Hi

were you able to resolve this?

I do no think is possible due to how reg_authn_req works.

Work around would be to  setup the PBX as a  regular "device" that  is authorized by IP.

[fmateo05]

I was able to route calls before,  using this method

You must set the domain (or IP) of the remote PBX (not the kazoo server). 

The remote PBX must have the SIP signaling and media ports exposed  to public network (open) 

Add a number to that trunkstore. When a call is originated to that number, Kazoo will route the call to your remote PBX

Also, when dialing the remote PBX trunk for outbound call., It will route it to kazoo as an outbound calling (i dont fully remember if you must add the remote PBX's IP as a trusted ACL on Kazoo)